Leaks in your roof can cost you a lot of discomforts or even damage depending on where they are. Some leakages may be happening in places that you do not access very often and therefore are hard to notice. You need to keep checking your roof regularly for any minor leaks. If you neglect your roof, you might end up needing to replace it altogether. That is expensive. It is much better to handle this problem immediately it arises. So, how do you fix a leaking roof at a low cost?
1. Fixing flat roofs
If you have a flat roof that has small holes, patching is one of the options that you have. To patch your flat roof, you will need scissors, a flat-roof roller. A brush and of course the primer and patching system. Start off by cleaning the damaged area to remove any loose material. Proceed to apply the primer there. Allow the primer to dry off (Check your instructions for this). Cut the patching material. Which should be self-adhesive, and apply it to the primed area to cover the holes and overlap to the undamaged part of the roof.
2. Fixing cracked flashing
Your flashing can corrode or crack as a result of age or extreme weather conditions causing leaks. The flashing is the strip of metal creating a water-resistant barrier between roof joints. The solution to this is simply removing the old nails and nailing a new metal strip. Make sure that you reseal with some roofing tar.
3. Fixing broken or missing shingles
Shingles get removed or broken during a storm. If not fixed as soon as possible, this can lead to a bigger roofing problem. Remove the broken shingle by sliding a pry bar under it and lifting to pop up the nails holding it. Nail the replaced shingle with four new nails.
4. Fixing vent boot
The gasket that seals the roof vents can crack and lead to leaks. The vent boots can be either plastic, metal or a combination of the two. Leaks on the vent boot leave dark spots and a stale odor. To fix this, cut the old boot with a knife and install the new one under the shingles and over the vent. Secure with some roofing nails and seal with caulk.
5. Fixing asphalt shingles
Asphalt shingles are popular due to their affordability and simplicity to install. With proper maintenance, they can last up to 20 years. A broken or torn shingle can cause damage to a house as rain penetrates around the nails. To repair an asphalt shingle, you will need a pry bar, hammer, roofing nails, roofing adhesive and the replacement roofing shingle. Remove the damaged shingle by lifting it from the roof and pulling out the nails. Lift the tab above the area damaged using a pry bar and slide the shingle to the position. Fasten it with the nails and coat each nail head with the adhesive. Press the shingle into place.
Always remember that preventative measures will save you a lot of money and resources as compared to reactive maintenance. Make an effort to inspect leaks and potential leaks before they become a major concern that can cost you a lot of money. Be vigilant and act fast.